Supporter - Olivetti DR N17 Service Manual

4.6.11 Supporter

Removal
1 Remove the Paper Handling Unit Assembly ( REP 4.5.1 Paper Handling Unit Assembly ).
2 Raise the Paper Handling Unit Assembly approximately 90 degrees.
3 Remove the wire harnesses connected to the No Toner Sensor and the Registration Sensor
away from the Supporter.
4 Remove the Lever Spring (1).
5 Remove the three screws securing the Supporter to the Registration Plate as well as the screw
securing the Supporter to the Bottom Chute.
6 Use tweezers to release the latch up out of the Front Tray Gear shaft, and pull off the Supporter
along with the Front Tray Gear (2).
CAUTION!
4-34
The Registration Bushing (3) and the P/Registration Bushing (4) might fall off
simultaneously. Be careful not to lose them.
687200Q