Diagnostic Mode 2 Error And Status Codes - Olivetti DR N17 Service Manual

5.3 Diagnostic Mode 2 Error and Status Codes

NOTE: These error codes may be displayed on the printer control panel if a fault condition is detected
during Diagnostic Mode 2 operation when the print engine cannot access the normal system
error messages. See 5.3.1 Error/Status Code Display Conditions, Printer Action, and Recovery
Procedures for more detailed information on these status codes.
Error/Status
Code
U6
U2
U4
U5
U1
E11
E9
E5
E8
E7
E4
E3
E2
E1
687200Q
Table 5.3.0.1 Error and Status Code Table
Message Displayed on LCD
NV MEMORY FAIL
PRINTER FAULT
U2: LASER FAIL
PRINTER FAULT
U4: FUSER FAIL
PRINTER FAULT
U5: FAN FAIL
PRINTER FAULT
U1: MOTOR FAILURE
PRINTER FAULT
E11: T2/3 REMOVED
PRINTER FAULT
E9: OCT REMOVED
PRINTER FAULT
E5: CLOSE COVERS
PRINTER FAULT
E8: ENV. REMOVED
PRINTER FAULT
E7: DUP REMOVED
PRINTER FAULT
E4: OPEN COVERS
PRINTER FAULT
E3: OPEN COVERS
PRINTER FAULT
E2: OPEN COVERS
PRINTER FAULT
E1: OPEN COVERS
There is a problem in the Print Engine
Controller Nonvolatile Memory (CPU).
There is a problem in the Laser Assembly.
There is a problem in the Fuser.
There is a problem in the Fan.
There is a problem in the Main Motor.
Paper Tray 2 or 3 is removed.
The OCT Unit is removed.
An interlock switch is open (Front Cover
or Rear Cover).
The Envelope Feeder is not in place.
The Duplex Module is not in place.
There is a paper jam in the Exit Sensor
area (Exit jam).
There is a paper jam between the Regis-
tration Sensor and the Exit sensor (Regis-
tration jam).
There is a paper jam between the current
Feeder Assembly and the Registration
Sensor (Misfeed jam).
There is a paper jam in the Duplex Mod-
ule (Refeed jam).
Service Manual
Description
5-71