Sheet Paper Feeder And Trays Reps; Feeder 2 And 3 (Optional) - Olivetti DR N17 Service Manual

8.3 500 Sheet Paper Feeder and Trays REPS

8.3.1 Feeder 2 and 3 (Optional)

NOTE: The removal procedure for Feeders 2 and 3 are different. Skip the steps for Feeder 3 in the
procedure below when Feeder 3 is not installed.
Removal
1 Pull out the Tray of Feeder 2.
2 Pull out the Tray of Feeder 3.
3 Remove the Feeder 2 Connector Cover (1, 2 in the illustration below). Disconnect the connector
of the harness of Feeder 2 by pulling downward (3 in the illustration below).
4 Remove the Feeder 3 Connector Cover (1, 2 in the illustration below). Disconnect the connector
of the Feeder 3 Connector Harness by pulling downward (3 in the illustration below).
5 Remove the Stopper Handles which secure the printer and Feeder 2 to each other (4, 5 in the
illustration below).
6 Remove the Stopper Handles which secure Feeder 2 and Feeder 3 to each other (4, 5 in the
illustration below).
7 Lift the printer off
Feeder 2.
8 Lift Feeder 2 off Feeder
3.
Replacement
Perform the removal steps in reverse order.
8-10
SAS483F
Figure 8.3.1.1 Removing Feeder 2 and 3
2
1
3
4
5
687200Q