Insert Tray X Message (C3) - Olivetti DR N17 Service Manual

7.3.11 "Insert Tray X" Message (C3)
1 Ensure the Size Sensor Assembly shows a correct switch combination for the size of the print
sheets present in Tray 1 when the tray presses the Size Sensor Assembly Spring.
NOTE: Ensure the paper guide in the back of the tray is adjusted properly.
NOTE: Remove Tray 1, and perform a visual inspection while inserting the tray into the slot.
Y: Go to step 2.
N: Replace Tray 1.
2 The parameter for the Diagnostic Mode 1 (Paper Tray Size) is compatible with the switch
combination shown on the Size Sensor Assembly.
NOTE: You can inspect this by changing the position of the Size Spring.
Y: Replace the Print Engine Controller.
N: Go to RAP 7.4.15 Size Sensor Assembly Failure.
687200Q Service Manual 7-27