Olivetti DR N17 Service Manual page 489

3
12
Replacement
Perform the removal steps in reverse order.
NOTE: Align the lower half of the Torque Clutch Assembly with the pin on the shaft (See (13) in Figure
11.3.5.1).
NOTE: Position the Torque Clutch Assembly Stop to align with the Rotation-Prevention Bracket and slide
the upper half onto the lower half (See (14) in Figure 11.3.5.1).
NOTE: If the Envelope Feeder Solenoid Bearing is not installed, the body of the Envelope Feeder
Solenoid is visible through the peephole beside the bearing hole in the outside surface of the
Side Cover.
NOTE: Verify proper alignment of One Way Clutches to their respective gears (See (1) & (2) in Figure
11.3.5.1).
687200Q
Figure 11.3.5.1 One Way Clutch Assemblies Removal
J230
4
6
7
Service Manual
5
8 8
13
9
10
2
11
14
1
FRONT
SAS4C9FA
11-13