Oct Raps; Offset Bin Fail - Power Off/On (E9) - Olivetti DR N17 Service Manual

9.7 OCT RAPS

NOTE: Refer to the Wiring Diagram 9.6.1 when problem solving the following RAPS.

9.7.1 Offset Bin Fail - Power Off/On (E9)

1 There is +5VDC between J209-7 and J209-8.
Y: Go to step 2.
N: Go to step 4.
2 Check the OCT PWB. The voltage between J209-1 and J209-8 is at the low level.
Y: Go to step 3.
N: Replace the OCT PWB.
3 Check the Print Engine Controller. The voltage between J21-1 and J21-8 is at the low level.
Y: Replace the Print Engine Controller.
N: Replace the OCT Harness Assembly.
4 Check the LVPS. There is +5VDC between J21-7 and J21-8.
Y: Replace the OCT Harness Assembly.
N: Go to RAP 7.4.5 Low Voltage Power Supply (LVPS) Assembly Failure (+5VDC).
687200Q Service Manual 9-31