Offset Assembly/Exit Sensor Assembly - Olivetti DR N17 Service Manual

9.3.9 Offset Assembly/Exit Sensor Assembly

Removal
1 Remove the Lower Chute ( REP 9.3.6 Lower Chute/Full Stack Sensor/Full Stack Actuator) .
2 Remove the Lever from the OCT Guide.
3 Disconnect the connector from P223 of the PWB.
4 Release the Connector Harness Assembly (J223) disconnected from P223 from the wiring path.
5 Remove the two screws which fasten the Offset Assembly.
6 Raise and slide the Offset Assembly off of the Roll Assembly and disconnect connector J226
from the OCT Home Sensor.
7 Remove the Offset Assembly.
8 Disconnect connector J227 of the Exit Sensor Assembly.
9 Press the latches with a screwdriver to detach the sensor.
Figure 9.3.9.1 Removing the Offset Assembly/Exit Sensor Assembly
Replacement
Perform the removal steps in reverse order.
9-16
J227
J223
J226
SAS4AAFA
687200Q