No Paper Actuator - Olivetti DR N17 Service Manual

11.3.10 No Paper Actuator

Removal
1. Remove the Feed Roll Assembly-1 (REP 11.3.9).
NOTE: It is not necessary to remove the Feed Roll Assembly-2. or Feed Belt.
2. Press the No Paper Actuator from the side of the surface on which envelopes are stacked toward the
bottom. This will remove the No Paper Actuator from the retaining tabs of the lower Bearing.
3. Slide the No Paper Actuator off the upper bearing hole.
SAS4CFFA
Replacement
Perform the removal steps in reverse order.
687200Q
Figure 11.3.10.1 No Paper Actuator Removal
Service Manual
FRONT
11-21