6) Paper Exit Jam (Error 382); Paper Exit Jam (Error 382); Paper Eject Jam Occurred Immediately After Turning On The Printer - Olivetti d-Color P116 Service Manual

7.4.2.(6)

Paper Exit Jam (Error 382)

(6-1)

Paper eject jam occurred immediately after turning on the printer.

Confirmation Items
(6-1-1) Check paper-ejecting route condition
Paper-ejecting route across
paper eject part.
(6-1-2) Check the mechanical parts condition
Check the paper-ejecting
sensor lever.
(6-1-3) Check the electrical parts condition
Check the condition of sensor
signal detection.
Check the output level of
EXIT sensor.
Check the power supply of
rear sensor relay board (ZAK
PCB).
(6-1-4) Check the connection
Signal wire of rear sensor
relay board, EXIT sensor
cable
Signal wire of rear sensor
relay board, EXIT sensor
cable
Y110260-4
Confirmation Tasks
Check whether the paper jam occurred during the route.
Check whether there is something abnormal about the form of
sensor lever and its movement.
By using the switch scanning test function of the maintenance
utility, check whether the sensor signal has been normally
detected.
Check the following signals of RSNS connector of main board
(TB3 PCB).
9pin: EXIT sensor
Operate and adjust the sensor lever in order to check the above
signal level.
Check the power supply of 5V of CN2 connector of rear sensor
relay board (ZAK PCB).
1pin: 5V power supply
3pin: 0VL
Check whether FFC has been inserted into RELAY connector of
main board (TB3 PCB) and CN1 connector of rear sensor relay
board (ZAK PCB) normally.
Check whether the cable between color difference sensor board
(ZAK PCB) and EXIT sensor has been connected normally.
Check whether wire gnawing, peel-off or defective cable
assembly exists.
d-Color P116 Service Manual
Action at NG
Remove the jammed
paper.
Replace the sensor
lever with a new one.
Replace the main
board (TB3 PCB) or
EXIT sensor or the
connecting cable with
new one.
Replace the EXIT
sensor with a new one.
Replace the connecting
cable with a new one.
Connect normally.
Replace the connecting
cable with a new one
and reassemble
normally.
171