Table of Contents
Advertisement
STEERING WHEELS AND COLUMNS
384-23
Fig.
384-58
Removing Housing
Fig.
384-56
Removing Pivot Pin
Fig.
384-59
Removing Dimmer Switch Rod and Support
Fig.
384-57
Removing Dimmer Switch Mounting Screw
12. Install buzzer switch and spring clip.
NOTE: It may be necessary to reach inside cover bore
and depress contacts so switch seats fully. Key warning
buzzer switch must be -installed before ignition lock
assembly is installed.
Fig.
384-60
Installing Rod Actuator
13. Install lock, hold lock cylinder sleeve and rotate knob
clockwise against stop. Insert cylinder into cover bore with
key on cylinder sleeve aligned to keyway in sector. Rotate
knob counterclockwise, maintaining a light push inward on
cylinder, until drive section ofcylinder mates with drive shaft.
Push in until snap ring snaps into groove and lock cylinder
is secured in cover. Check freedom of rotation.
14. Refer to "TURN SIGNAL SWITCH" (Tilt-Away)-
.
,
Installation-Steps
1-4.
15. Install hazard warning knob and screw.
16. Seat ball of actuator arm into pivot slot. Fit arm into
signal switch slot, install screw and torque to 20 in. lbs. (Fig.
Advertisement
Table of Contents
