Table of Contents
Advertisement
STEERING WHEELS AND COLUMNS
384-9
LOCK
PLATE
Fig. 384-1 1 Lock Plate and Cancelling Cam
I
I
Fig. 384-1
2
Installing Wire Snap Ring
HAZARD
WARNING
I
-TURN
s
I
GNAL
UL
SWITCH ATTACHING
R
SCREWS
Fig. 384-1 3 Turn Signal Switch Attachment
14. Connect turn signal wiring connector to harness,
then position connector into bracket on right side of jacket
(Fig. 384- 14).
15. Install instrument panel lower trim cap or lower trim
panel.
I
Fig. 384-1 4 Column Wiring Connectors
IGNITION LOCK ASSEMBLY (TILT-
AWAY)
Removal
1 . Disconnect negative cable from battery.
2. Refer to STEERING WHEEL-Removal.
3. Lock plate cover may be removed for replacement at
this time by releasing as shown (Fig. 3B4-9).
4. Position Tool J 23653 over steering shaft. Tighten nut
until tool slightly depresses lock plate. Pry wire snap ring
from shaft and discard (Fig. 3B4-10). Remove Tool J 23653.
5. Remove lock plate and cancelling cam (Fig. 3B4-11).
6. Remove upper bearing preload spring.
7.
Position turn signal lever in the right turn position,
then remove turn signal lever attaching screw and lever (Fig.
3B4- 13).
8. Push in on hazard warning knob, then remove screw
and hazard warning knob.
16. Connect negative battery cable.
Advertisement
Table of Contents
