Remove And Replace Rotating Group; Remove And Replace Seals; Remove And Replace Thrust Plate And Rotor - Pontiac TRANS AM 1977 Service Manual

383-34 1977 PONTIAC SERVICE MANUAL
DISASSEMBLY ASSEMBLY
1 . W l T H PLASTIC HAMMER, TAP 1 . INSTALL RING AS SHOWN I N
LIGHTLY UNTIL PRESSURE VIEW A.
PLATE I S FREE.
2. INSTALL PARTS A S SHOWN.
2. REMOVE PARTS AS SHOWN.
HOUSING THRUST PLATE
3 9 5 8
Fig.
383-67
Remove and Replace Rotating Group
DISASSEMBLY ASSEMBLY
1 . REMOVE PARTS AS SHOWN.
1 . INSTALL DRIVE SHAFT SEAL AS
SHOWN I N V IEW A AND INSTALL
PARTS AS SHOWN. USE NEW "0"
RINGS AND SEALS. LUBRICATE
"0" RINGS WlTH POWER STEER-
ING FLUID BEFORE INSTALLATION.
DISASSEMBLY ASSEMBLY
1 . Remove retaining r i n g and 1 . Install parts as shown.
discard, then remove parts
as shown.
SEAL 3 9 5 9
Fig. 383-68 Remove and Replace Seals