Table of Contents
Advertisement
364-22
1977 PONTIAC SERVICE MANUAL
31 25
Fig.
384-52
Ignition Lock Removal
Fig.
384-54
Removing Cover
I
KEY WARNING
I
Fig.
384-55
Removing Cap and Rod Actuator
Fig.
384-53
Removing Key Warning Buzzer Switch
21. Remove upper bearing race and seat.
22. Install Tool J 21854-1 and remove pivot pins as
shown in Fig. 384-32.
23. Lift tilt lever to release lock shoes. Pull upward on
housing to extend rack fully down and moving housing to the
left, disengage rack from actuator.
24. With housing disengaged, rotate it clockwise to free
dimmer switch actuator rod (Fig. 384-58). Remove housing
from column.
25. Refer to "SUPPORT AND/OR SHIFT GATE"
(Tilt-Away)-Removal-Steps 2-5.
26. Remove dimmer switch actuator rod and support
and separate rod from support (Fig. 384-59).
Installation
1. Slip dimmer switch actuator rod through hole in
support. Install rod between bowl and jacket (Fig. 384-59).
2. Refer to "SUPPORT AND/OR SHIFT GATE"
(Tilt-Away)-Installation-Steps 4-7.
3. Position access hole of bearing housing over end of
actuator rod (Fig. 384-58). Rotate housing counterclockwise
to install dimmer switch actuator rod and assembly over
steering shaft.
4. Refer to "HOUSING" (Tilt-Away)-Installation-Steps
1-5.
5. Lift up on tilt lever and position housing in the center
position. Remove tilt lever.
6. Install pivot assembly and pivot pin in cover. Apply
grease to smooth portion of pivot pin.
7. Install rod actuator into cap and position cap over
housing (Fig. 384-55).
8. Guide end of rod actuator into pivot slot during cover
assembly (Fig. 384-60).
9. Install cover to housing attaching screws and torque
to 100 in. lbs.
10. Install race and seat as shown in Fig. 384-30.
11. Install tilt lever.
Advertisement
Table of Contents
