1977 R-4 Rotor & Bearing Asm.; Installing 1977 R-4 Clutch Rotor Bearing; Installing 1977 R-4 Rotor And Bearing Asm. (On Car); Installing 1977 R-4 Rotor & Bearing Asm. (On Bench) - Pontiac TRANS AM 1977 Service Manual

1 B-60
1977 PONTIAC SERVICE MANUAL
Fig. 18-107 1977 R-4 Rotor & Bearing Asm.
.
.
H A N D L E
/
J
9481
PULLEY BEARING
A N D PULLEY
INSTALLER
\
ROTOR
BEARING
A
ROTOR A N D m
HUB ASM.
7
Fig. 18-108 Installing 1977 R-4 Clutch Rotor Bearing
pulley rim assembly have been removed from the front head.
Be careful not to drop the Puller Guide, J 25031-1 when
removing the assembly.
2. Remove the pulley rim mounting screws and special
lock washers. Discard the lock washers.
3. Slide the pulley rim off the rotor and hub assembly.
The pulley rim and the clutch coil (Fig. 1 B- 1 1 1) are
replaceable at this point.
Replace
1. Assemble the clutch coil, pulley rim and the clutch
rotor and bearing assembly as shown in Fig. 1B-112. Use new
special lock washers and apply sealer (Loctite RC-75 or
equivalent) to screw threads but do not lock the screws in
place.
Fig. 18-109 Installing 1977 R-4 Rotor and Bearing Asm.
(On Car)
Fig. 18-1 1 0 Installing 1977 R-4 Rotor & Bearing Asm.
(On Bench)
2. Place the assembly on the neck of the front head and
seat into place using Rotor & Bearing Installer, J 26271 (Fig.
1B-110).