Table of Contents
Advertisement
TURBO HYDRA-MATIC 200
7A1-81
REAR
/CARRIER
Fig. 7 A l - 2 0 7 Removing Rear Carrier Bushing
REAR
'CARRIER
Fig. 7 A l - 2 0 8 Installing Rear Carrier Bushing
Fig. 7A1-209 Removing or Installing Case Bushing
SPECIFICATIONS
TRANSMISSION IDENTIFICATION
An identifying code is found on the serial number plate
of the turbo hydra-matic 200 transmission. This plate is
located on the right side of the transmission case.
The serial numbers on these plates are all preceded by
the year (77) and one of the following code letters
-
BH, BL,
BU, BZ, CE, OS, PY or PZ. The application of each code
is:
BH-23 1 cu. in., 2 bbl. engine, except California (HM
Series)
BL-231 cu. in., 2 bbl, engine, California only (X Series)
BU
-
231 cu. in., 2 bbl engine, California only (HM
Series)
BZ
-
231 cu. in., 2 bbl engine, except California (X
Series)
CE
-
305 cu. in., 2 bbl. engine except California (X
Series)
OS
-
350 cu. in. (Eng. code R), 4 bbl. engine (B Series)
PZ
-
301 cu. in., 2 bbl. engine, except California (B
Series)
On all Turbo Hydra-matic 200 transmissions, the vehicle
serial number is stamped:
1. On a pad located just above the bottom pan face on
the left hand side of the transmission below the parking pawl
area
-
or
2. On a pad above the parking pawl area
-
or
3. On the lower right hand side of the case bell housing.
PY
-
151 cu. in., 2 bbl. engine (H and HM Series) and
except California (X Series)
Advertisement
Table of Contents
