Turn Signal Wire Protectors; Installing Turn Signal Switch; Ignition Switch (Regular) Exc. X Series - Pontiac TRANS AM 1977 Service Manual

384-34 1977 PONTIAC SERVICE M A N U A L
SERVICE PROTECTOR
PRODUCTION PROTECTOR
Fig. 3B4-8 1 Turn Signal Wire Protectors
Fig. 3 8 4 - 8 2 Installing Turn Signal Switch
Fig. 3 8 4 - 8 3 lgnition Lock Removal
2. Using needle nose pliers, remove key warning buzzer
switch and spring clip ( ~ i ~ . 3B4-85).
NOTE: Care must be exercised on removal of switch so
that spring clip is not lost or damaged.
Fig. 3 8 4 - 8 4 Installing lgnition Lock
Fig. 3B4-85 Remove Key Warning Buzzer Switch
Installation
1. Assemble buzzer switch and spring clip with formed
end of clip under end of switch and spring bowed away from
switch on side opposite contact. Push switch and spring into
hole in cover to the stop with contacts toward lock cylinder
bore (Fig. 3B4-86).
NOTE: Make sure terminal prongs are not bent
downward during isntallation.
NOTE: Key warning buzzer switch must be installed
before ignition lock assembly is installed or the lock
moved to Run position.
2. Refer to IGNITION LOCK ASSEMBLY (Regular)-
Installation-Steps 1- 14.
IGNITION SWITCH (REGULAR) EXC. X
SERIES
Removal
1. Disconnect negative cable from battery.
2. Position ignition lock cylinder in "OFF-
UNLOCKED" position.