Table of Contents
Advertisement
384-1 8
1 9 7 7 PONTIAC SERVICE M A N U A L
-
- -
THRUST
SHIFT
TUBE
-
Fig. 384-39 Support Attachment
SHlFl
GATE
Fig. 384-40 Shift Gate Mounting
-
Fig. 384-4 1 Shroud Removal
-
H
Series
Installation
See CAUTION on Page 3B4-I of this Section.
NOTE: Apply thin coat of lithium grease to all friction
parts.
Fig. 384-42 Key Release Lever (Tilt-Away)
I. H Series Only
-
Install key release lever and spring
assembly into shroud by locating spring in shroud slot.
Compress spring and slip lever into shroud slot (Fig. 3B4-42).
2. H Series Only
-
Align shroud ribs with slots in jacket
and push into position. Install shroud retaining screws if
removed (Fig. 3B4-41).
3. Position shift gate (retainer plate on H Series) on
support and install attaching screws (Fig. 3B4-40).
4. Install support by aligning "V" in support with notch
in jacket (Fig. 3B4-43). Install the four screws through
support into lock plate. Torque screws to 60 in. Ibs.
ALIGN " V " W I TH
SLOT I N JACKET
Fig. 384-43 Aligning
"V"
In Support
5. All except H Series
-
Install shift lever into bowl as
shown in Fig. 3 ~ 4 - 4 4 , then remove shim and drive shift lever
retaining pin into place.
6. Install steering shaft (from inside of car) into column.
NOTE: It may be necessary to guide shaft through lower
bearing from under hood of car.
Advertisement
Table of Contents
