Table of Contents
Advertisement
3B4-12
1 9 7 7 PONTIAC SERVICE MANUAL
LOOP CABLE AS SHOWN
TO INSTALL IN LOCKING
INSTALLED POSITION
TAB
INSTRUMENT
CABLE THRU LOCKING TABS
(2 TABS)
INSTRUMENT CLUSTER
POINTER
81
CABLE
ASSEMBLY
POINTER ASM. TO CLUSTER
WITH TRANSMISSION IN NEUTRAL,
ADJUST CABLE RETAINER TO
COLUMN TO CENTER POINTER
CABLE RETAINER
ON "N" (NEUTRAL).
POINTER CABLE TO STEERING COLUMN
INSTRUMENT PANEL
- -
-
Fig.
3B4-18
Shift Indicator Cable
-
X
Series
knob counterclockwise, maintaining a light push inward on
cylinder, until drive section of cylinder mates with drive shaft.
Push in until snap ring snaps into groove and lock cylinder
is secured in cover. Check freedom of rotation.
5. Refer to T U R N SIGNAL SWITCH (Tilt-Away)-
Installation-Steps 1-1 6.
STEERING LOCK BOLT SPRING (TILT-
AWAY)
Removal
1. Refer to COVER (Tilt-Away)-Removal-Steps 1-5.
2. Remove tilt lever opening shield from housing (Fig.
3B4-25).
3. Remove spring attaching screw (Fig. 3B4-25), then
move rack assembly upward.
4. Turn spring clockwise until disconnected from
steering shaft lock bolt. Remove spring (Fig. 3B4-26).
Installation
NOTE: Apply thin coat of lithium grease to all friction
parts.
1. Install lock bolt spring so that hook of spring engages
lock bolt (in slot at lower end of lock bolt) and loop fits into
slot in sector.
2. Position spring and install attaching screw (Fig. 3B4-
25). Move rack assembly downward until stop is felt.
3. Install tilt lever opening shield into housing (Fig. 3B4-
25).
4. Refer to COVER (Tilt-Away)-Installation-Steps 1-5.
SECTOR AND/OR LOCK BOLT (TILT-
AWAY)
Removal
1. Refer to COVER (Tilt-Away)-Removal-Steps 1-5.
2. Remove tilt lever opening shield from housing (Fig.
3B4-25).
3. Remove lock bolt spring attaching screw (Fig. 3B4-
25), then move rack assembly upward.
4. Turn spring clockwise until disconnected from
steering shaft lock bolt. Remove spring (Fig. 3B4-26).
5. Using snap ring pliers, remove snap ring (Fig. 3B4-
27).
6. Remove sector from housing by pulling straight out
until sector is off lock drive shaft.
7. Lock bolt can now be removed from housing as shown
in Fig. 3B4-28.
Installation
NOTE: Apply thin coat of lithium grease to all friction
parts.
1. Install lock bolt into housing with flat of lock bolt
positioned as shown in Fig. 3B4-28.
Advertisement
Table of Contents
