Table of Contents
Advertisement
STEERING WHEELS AND COLUMNS
364-31
Fig. 384-74 Cover Attachment
Fig. 384-75 Removing Wire Snap Ring
5. Position turn signal switch in the neutral position.
NOTE: If the signal switch is not placed in "neutral"
position, assembly of the cancelling cam may cause
damage to the turn signal cancel springs in the signal
switch assembly.
6. Install hazard warning knob and turn signal switch
lever and attaching screw.
7. Install upper bearing preload spring.
8.
Install cancelling cam and lock plate as shown in Fig.
3B4-76.
9. Position new wire snap ring over steering shaft, then
install Tool J 23131 over shaft and tighten steering wheel
attaching nut until wire snap ring can be installed in groove
in steering shaft (Fig. 3B4-77). Remove Tool J 231 31.
CAM
4191
Fig. 384-76 Lock Plate and Cancelling Cam
SNAP
'RING
Fig. 384-77 Installing Wire Snap Ring
NOTE: Tool J 24542 mav be used instead of Tool
~
-
J
23 13 1 . Refer to Tilt-Away column procedures for usage.
10. If removed, install cover on lock plate (Fig. 3B4-74).
1 1 . Refer to STEERING WHEEL-Installation.
12. While holding column in place, remove nuts "A" and
"B" from bracket assembly. Insert wiring into wire protector
until slots in protector will align with weld nuts on column.
Advertisement
Table of Contents
