Table of Contents
Advertisement
7A1-42
1977 PONTIAC SERVICE MANUAL
Fig. 7A1-61 Removing Manual Shaft Seal From Case
Fig. 7A1-64 Removing Parking Brake Pawl Shaft Cup
Plug from Case
Fig. 7A1-62 Removing Parking Brake Bracket Bolt
7. Inspect for damaged or stripped bolt holes. If any
threaded holes require heli-coils or kquivalent, install thesk
to renew the threads.
8. Move transmission to vertical position, rear end up.
9. Inspect cooler line connectors for damage. Do not
remove unless replacing.
10. Inspect case bushing for damage or scoring.
11. If removed, install a new oil seal, using J 2 1426 (Fig.
7A1-68).
12. If vent was removed, apply Loctite primer "T", or
equivalent, to the outside diameter of the vent that locates
in the case and Loctite 35, or equivalent, to the vent hole in
the case. Install vent, using a rubber or plastic hammer.
13. If removed, install new cooler line washer(s) and
connector(s); torque to 20.0-27.0 N - m (15-20 ft. lbs.).
Advertisement
Table of Contents
