Table of Contents
Advertisement
STEERING WHEELS AND COLUMNS
384-37
Fig.
384-9
1
Key Release Lever and Spring Position
Fig.
3 8 4 - 9 2
~ e y ~ e l e a s e
Wave Washer
3. If key warning buzzer switch was removed, assemble
buzzer switch and spring clip with formed end of clip under
end of switch and spring clip bowed away from switch on side
opposite contact. Push switch and spring into hole in housing
to the stop with contacts toward lock cylinder bore (Fig. 3B4-
86).
NOTE: Key warning buzzer switch must be installed
before ignition lock assembly is installed.
4. (Exc. X, F and H Series) Remove the two nuts "A"
and "B" from bracket assembly (Fig. 384-80) and lower
column until column rests on seat cushion.
(F, X and H Series) Remove the two nuts "A" and "B"
from bracket assembly (Fig. 384-80) and lower column until
ignition switch can be installed.
5. Check ignition switch to be sure switch is in "OFF-
UNLOCK" position, Fig. 3B4-87, then fit switch over
actuator rod and install screws. Torque to 35 in. Ibs.
6. Raise column into position and loosely install nuts
"A" and "B". If spacers were removed, install in equal
amounts on each side.
1.
INSERT
SHIM
OVER
TOP
OF
SPRING.
2.
INSERT SHIFT LEVER.
3.
INSTALL
PIVOT
PIN.
4. REMOVE
SHIM.
Fig.
384-93
Shift Lever Installation
7. Install lock, hold lock cylinder sleeve and rotate knob
clockwise against stop. Insert cylinder into cover bore with
key on cylinder sleeve aligned to keyway in housing (Fig.
3B4-84), push into abutment of cylinder and sector. Rotate
knob counterclockwise, maintaining a light push inward on
cylinder, until drive section of cylinder mates with drive shaft.
Push in until snap ring pops into groove and lock cylinder
is secured in cover. Check freedom of rotation.
8. Position lock assembly in "ACC" position.
9. Refer to TURN SIGNAL SWITCH (Regular)-
Installation-Steps 2- 1 1.
10. (Exc. F, X and H Series) Torque toe-pan clamp bolts
to 60 in. Ibs.
11. (Exc. F, X and H Series) Torque nuts "A" and "B"
to 25 ft. lbs. (Fig. 3B4-80).
12. (F, X and H Series) Loosely install toe-pan bolts then
torque nuts "A" and "B" to 25 ft. lbs.
13. Torque toe-pan bolts to 45 in. Ibs.
14. Install trim cover over toe-pan.
15. If equipped with column shift (Automatic) install
shift indicator needle, link or cable on shift bowl and adjust
as shown in Figs. 384-16, 384-17 and 3B4-3 8.
16. Install trim cap or lower panel to lower portion of
instrument panel.
17. Connect negative cable to battery.
SHIFT GATE (REGULAR) EXC. H SERIES
Removal
1. Refer to HOUSING (Regular)-Removal-Steps 1- 12.
2. Remove two attaching screws and remove shift gate
(Fig. 3B4-94).
Installation
1. Install shift gate as shown in Fig. 384-94.
2. Refer to HOUSING (Regular)-Installation-Steps 1-
23.
Advertisement
Table of Contents
