Removing 1977 R-4 Rotor & Bearing Asm. Retainer Ring; Removing 1977 R-4 Clutch Rotor Asm.; Installing 1977 R-4 Rotor & Bearing Puller Guide; R-4 Compressor Clutch Coil And/Or Pulley Rim - Pontiac TRANS AM 1977 Service Manual

CUSTOM AIR CONDITIONING
16-59
IER
1 3
-
Fig. 18-103 Removing 1977 R-4 Rotor & Bearing Asm.
Retainer Ring
Fig. 18-1 0 4 Installing 1977 R-4 Rotor & Bearing Puller
Guide
7. Rotate the pulley rim and rotor to insure that pulley
rim is rotating "in-line". If pulley rim is distorted (does not
rotate in-line) adjust or replace pulley rim.
8. Tighten pulley rim mounting screws to 100 inch-
pounds torque and lock screw heads in place by bending
special lock washers (Fig. 1B-110).
9. Reinstall clutch plate and hub assembly according to
its procedure.
Fig. 18-105 Removing 1977 R-4 Clutch Rotor Asm.
Fig. 18-106 1977 R-4 Clutch Rotor Bearing Removal
R-4 COMPRESSOR CLUTCH COIL AND/
OR PULLEY R I M
Remove
1. Perform steps 1 through 4 of "Clutch Rotor and/or
Bearing" Removal procedure but do not loosen or remove the
pulley rim mounting screws until the clutch rotor, coil and