Table of Contents
Advertisement
TURBO HYDRA-MATIC 200
Fig. 7A1-40 Removing Forward and Direct Clutch
Assemblies
-
-
Fig. 7A1-43 Location of Front Selective Washer
Fig. 7A1-44 Installing Tools on Rear End of Case
Fig. 7A1-4 1 Removing lntermediate Band Assembly
Fig. 7A1-45 Checking Rear Unit End Play
Fig. 7A1-42 Removing lntermediate Band Anchor Pin
d. Move output shaft upward by turning adiustinn screw
on
J
25013-5 until the whit; or scribed line on sieeve i25013
begins to disappear; then read end play should be 0.10-
0.64mm (.004"-.025").)
NOTE: Selective washer controlling this end play is
located between the front internal gear thrust washer
and output shaft snap ring. If more or less washer
thickness is required to bring end play within
specifications, select proper washer from the following
chart:
Advertisement
Table of Contents
