Low And Reverse Clutch Housing-Exploded View; Removing Low And Reverse Clutch Spring Retaining Snap Ring; Removing Wave Release Spring; Removing Or Installing Clutch Outer/Inner Seal - Pontiac TRANS AM 1977 Service Manual

1 9 7 7 PONTIAC SERVICE MANUAL
LO&REVERSE LO & REVERSE LO & REVERSE
CLUTCH LO&REVERSE CLUTCH LO & REVERSE CLUTCH
HOUSING LO & REVERSE CLUTCH APPLY SPRING STEEL CLUTCH SELECTIVE
ASSEMBLY PISTON SEALS RING RETAINER PLATE WASHER
SNAP HOUSING LO & REVERSE WAVE SNAP LO & REVERSE
RING TO CASE PISTON RELEASE RING COMPOSITION-
(HOUSING SPACER ASSEMBLY SPRING FACED PLATE
TO CASE)
Fig. 7A1-89 L o w and Reverse Clutch Housing
-
Exploded View
1535
CLUTCH HOUSING
Fig. 7A1-90 Removing L o w and Reverse Clutch Spring
Retaining Snap Ring
Fig. 7 A 1 - 9 1 Removing Wave Release Spring
CLUTCH PISTON
\
CLUTCH OUTER SEAL
(LIP UP) 1538
Fig. 7A1-92 Removing or Installing Clutch Outer Seal
(LIP up)
1537
-
Fig. 7A1-93 Removing o r Installing Clutch Inner Seal
J
J
4. Inspect low and reverse clutch piston and clutch apply
ring assembly for distortion, cracks or damage.
3. Inspect low and reverse clutch splines and snap ring
NOTE: The apply ring is identified by a number located
groove for damage or burrs. Remove any burrs on splines or
on the ring. The ring usage and identification are as
snap ring groove.
follows: Models CE, CD, CK, CO, CR, CY, OS and PZ
are identified by number 7. Models BH, BL, BU, BZ,
OW and OZ are identified by number 8. Models BR,