Accelerator Control Cable 301 Engine Vi Code Y; Accelerator Control Cable 350 Engine Vi Code L; Accelerator Control Cable 305 Engine Vi Code U - Pontiac TRANS AM 1977 Service Manual

FUEL SYSTEM 6C-7 1
CAUTION: CARE MUST BE UTILIZED
IN PRESSING THE RETAINER INTO HOLE
IN ROD TO ASSURE THE CABLE IS
NOT KINKED OR DAMAGED IN ANY WAY.
\
NOTE: SLIP ACCELERATOR CONTROL
CABLE THRU SLOT IN ROD. INSTALL
RETAINER. BEING SURE I T IS SEATED.
AUTION: NO WIRES, HOSES,
ABLES, ETC. ARE TO BE ROUTED
HROUGH THIS OPENING.
bBM
Fig. 6C-128 Accelerator Controls
H
Series
TO DASH
\
THROTTLE RETURN SPRING
Fig. 6C-129 Accelerator Control Cable 301 Engine V I
Code
Y
3. Disconnect and plug other hoses as directed on
Emission Control Information Label under the hood.
4.
Engine must be at normal operating temperature,
choke open, air conditioning off.
5. Connect an ACCURATE tachometer to engine.
6. Disconnect vacuum advance and plug hose. Check
ignition timing. If necessary, adjust to specification shown on
Emission Control Information Label. Reconnect vacuum
advance.
NOTE: On cars with electronic spark timing, follow
instructions on Emission Control Information Label
very carefully.
NOTE: ROUTE CABLE
OVER SPARK PLUG WIRES.
CAUTION: FLEXIBLE COMPONENTS (HOSES.
WIRES,CONDUITS, ETC.) MUST NOT BE ROUTED
WITHIN 2 INCHES OF MOVING PARTS OF
ACCELERATOR LINKAGE FORWARD OF SUPPORT 1
UNLESS ROUTING IS POSITIVELY CONTROLLED.
Fig. 6C-130 Accelerator Control Cable 350 Engine VI
Code L
NOTE: ROUTE CABLE
OVER SPARK PLUG WIRES.
CAUTION: FLEXIBLE COMPONENTS (HOSES,
WIRES, CONDUITS, ETC.) MUST NOT BE ROUTED
WITHIN 2 INCHES OF MOVING PARTS OF
ACCELERATOR LINKAGE FORWARD OF SUPPORT,
UNLESS ROUTING IS POSITIVELY CONTROLLED.
Fig. 6C-13 1 Accelerator Control Cable 305 Engine VI
Code
U
7. Carefully remove caps from idle mixture screws. Be
careful not to bend screws. Lightly seat screws, then back out
EQUALLY just enough so engine will run.
8. Place transmission in Drive (automatics) or Neutral
(manuals).
9. Back each screw out (richen) 1/8 turn at a time until
maximum idle speed is obtained. Then set idle speed screw
to value shown in Chart Column A. Repleat Step 9 to be
certain you have maximum idle speed.