Removing Servo Cover And Seal; Removing Intermediate Servo; Direct Clutch Accumulator Port; Intermediate Band Apply Pin Tools - Pontiac TRANS AM 1977 Service Manual

7A1-34 1 9 7 7 PONTIAC SERVICE MANUAL
Fig. 7 A l - 2 9 Removing Servo Cover and Seal
Fig. 7 A 1 - 3 0 Removing lntermediate Servo
8. Check for proper intermediate band apply pin as
follows:
a. Install J 25014-2 in intermediate servo bore and retain
with intermediate servo cover retaining ring, aligning ring
with gap at case slot (Fig. 7A1-33).
b. Install pin J 25014-1 into J 25014-2.
CAUTION: Make sure the tapered pin end is
properly located against the band apply lug. Also,
make sure the band anchor pin is properly located
in the case and band anchor lug.
c. Install dial indicator J 8001 and position dial indicator
point on top of J 25014-2 zero post and set dial indicator to
zero.
NOTE: Seat J 25014-2 squarely against the servo
retaining snap ring.
d. Align stepped side of pin J 25014-1 with torquing arm
of J 25014-2. Arm must stop against step of pin J 25014-1.
NOTE: If band selection pin does not register between
the high and low limits, look for possible problem with
the intermediate band, direct clutch or case.
APPLY AIR PRESSURE.
HERE TO. REMOVE
Fig. 7A1-3 1 Direct Clutch Accumulator Port
Fig. 7A1-33 lntermediate Band Apply Pin Tools
e. Apply 12 N . m (100 lbs. in.) of torque to hex nut on
side of gage. Slide dial indicator over pin J 25014-1 (Fig.
7A1-34). Read dial indicator and see Fig. 7A1-35 below for
proper size.