Console Shift Controls-"X" Series Shown; Transmission - Pontiac TRANS AM 1977 Service Manual

7A1-30 1977 PONTIAC SERVICE MANUAL
INSTALL BUTTON SO
TOP OF LETTERS ARE
THIS RING T O BE INSTALLED
TOWARDS FRONT O F CAR
WITH CURVED SIDE UP
\
J
CLIP SPRING
SELECTOR LEVER
CHASSIS LUBRl
(20 LB. FT.)
3868
Fig. 7A
1
-
17 Console Shift Controls
-
"X" Series Shown
UNIT REPAIR
TRANSMISSION
6. Remove catalytic converter support bracket.
Removal
1. Inside engine compartment, disengage "Snap Lock"
(Figs. 7A1-12 or 13)
T.V.
cable.
2. Remove transmission oil level dipstick, upper bolt
retaining filler tube to engine (Fig. 7A1-14) and remove tube
from transmission case.
3. Hoist car.
4. Remove retaining bolt for T.V. cable (Figs. 7A1-12
or 14). Remove
T.V.
cable from link. Plug hole.
5. Disconnect transmission cooler lines at transmission
(Figs. 7A1-10 or 1 1).
7. Remove flywheel cover pan and three bolts holding
the converter to the flywheel. Support engine.
NOTE: Mark flywheel and converter for reassembly in
the same manner.
8. Disconnect speedometer cable.
9. Remove cotter pin and manual shift linkage from
selector lever (Fig. 7Al- 15). If console equipped, remove
spring clip and
T.V.
cable from bracket at transmission (Figs.
7A1-16 or 17).
10. Remove propeller shaft.