Table of Contents
Advertisement
TURBO HYDRA-MATIC
200
7A1-75
FOR IDENTIFICATION
Fig. 7A1-18 1 Valve Body Spacer Plate
Fig. 7 A 1 - 1 8 2 Installing 5th Check Ball In Case
Rear Bushing
a. Place direct clutch housing with the thrust washer face
down on a block of wood to prevent damaging the thrust
washer surface (Fig.
7A 1- 199).
b. Using tool J
25019-4
with Driver Handle J
8092,
remove bushing (Fig.
7A 1
-
199).
c. Using tool J
25019-6
with Driver Handle J
8092,
drive
or press new bushing, part number
8628917,
or equivalent
into place until tool bottoms (Fig.
7A1-200).
Front Internal Gear Bushing
a. Using tool J
25019-3
with Driver Handle J
8092,
remove bushing (Fig.
7A 1-20 1).
b. Using tool J
25019-9
with Driver Handle J
8092,
drive
or press new bushing, part number
8628925,
or equivalent
into place until tool bottoms (Fig.
7A1-202).
Rear Sun Gear
a. Using tool J
25019-14
with Slide Hammer J
7004-1,
remove bushing (Fig.
7A 1-203).
b. Place rear sun gear with gear side down on block of
wood to prevent damaging the gear (Fig.
7A1-204).
c. Use tool J
25019-2
with Driver Handle J
8092,
drive
or press new bushing, part number
8628928,
or equivalent
into place until tool bottoms (Fig.
7A1-204).
Lo and Reverse Clutch Housing Bushing
a. Using tool J
25019-16
with Slide Hammer J
7004-1,
remove bushing (Fig.
7A 1-205).
b. Place lo and reverse clutch housing with splined hub
between two blocks of wood to prevent damaging the splines
(Fig.
7A1-206).
c. Using tool J
25019-8
with Driver Handle J
8091,
drive
or press new bushing, part number
8628929,
or equivalent
into place until tool bottoms (Fig.
7A1-206).
Rear Carrier Bushing
a. Using tool J
25019-16
with Slide Hammer !
7004-1,
remove bushing (Fig.
7A 1-207).
Advertisement
Table of Contents
