Speedometer Driven Gear; Checking Transmission Mount; Console Shift Controls - Pontiac TRANS AM 1977 Service Manual

Table of Contents

Advertisement

TURBO HYDRA-MATIC 2 0 0
7A 1-25
3. Route cable in front of filler tube and clamp to filler
tube at the filler tube bracket.
4. Pass cable through bracket and engage locking tube
of "Snap Lock'.' on bracket.
5. Connect cable to carburetor lever.
6. Install air cleaner.
Adjustment
1. Disengage "Snap Lock" (Cable should be free to slide
thru "Snap Lock").
2. With cable installed in support and attached to
transmission and carburetor lever, move carburetor lever to
wide open throttle position.
3. Push "Snap Lock" flush and return carburetor lever
to closed position.
SPEEDOMETER DRIVEN GEAR
Removal and Installation
1. Disconnect speedometer cable.
2. Remove retainer bolt, retainer, speedometer driven
gear and
" 0
ring seal.
To install, reverse removal procedure, using new
" 0
ring seal (if required) and adjust fluid level.
CHECKING TRANSMISSION MOUNT
Raise car on a hoist. Push up and pull down on
transmission tailshaft while observing transmission mount. If
rubber separates from metal plate of mount or if tailshaft
moves up but not down (mount bottomed out) replace mount.
If there is relative movement between a metal plate of mount
and its attaching point, tighten screws or nuts attaching
mount to transmission or crossmember.
COLUMN SHIFT CONTROLS
(Fig. 7A1-15)
Adjust
1. Looses screw on adjusting swivel clamp.
2. Position steering column shift lever in NEUTRAL
gate notch.
3. Set transmission selection lever in NEUTRAL detent.
NOTE: Obtain NEUTRAL detent by moving selection
lever counterclockwise to its stop, then clockwise three
detents to NEUTRAL.
4. Tighten screw on adjusting swivel clamp to 27 N - m
(20 Ib. ft.).
CONSOLE SHIFT CONTROLS
(Figs. 7A1-16 and 17)
Adjust
1. Loosen nut from pin at selection lever.
2. Position shift on assembly in NEUTRAL position.
3. Place transmission selector lever in NEUTRAL
detent.
4. Tighten nut on pin at selector lever to 27 N - m (20
lb. ft.).
27 N'm
- -
(20 LB. FT.)
t
BOLT FROM FRONT
\
-1
OF ENGINE)
FRONT OF CAR
Fig. 7A1-1 1 Oil Cooler Lines (Typical)
-
V8 Shown

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firebird 1977

Table of Contents