Configuring The Mpe Settings - Cisco D9854 Installation And Configuration Manual

Hide thumbs Also See for D9854:

Table of Contents

Configuring the MPE Settings

From the user interface of the D9854/D9854-I, click System Settings > IP

Settings > MPE. The MPE page is displayed.

From the MPE Data Filter Mode drop-down list, choose whether the MPE data

is forwarded to the network (Forward None, Forward All, or Forward Filtered).

Choose Forward None to not forward MPE data to the network. Choose

Forward All to forward all the MPE data to the network. Choose Forward

Filtered to only forward the MPE data from the defined Static Multicast Filtering

table below to the network. For more information on configuring the Static

Multicast Filtering table, see To Add a Static Multicast Filtering (on page 272).

Note: The receiver supports up to a maximum of 10 Mbps throughput when

forwarding 1500 byte packets.

Configuring System Settings