Cisco D9854 Installation And Configuration Manual page 113

Menu Item Description
Gateway Sets the Network Gateway Address
on the Network, used to expose the
receiver to a WAN.
Phy Mode Set the speed and duplex type of the
interface. Select Auto for PHY to
negotiate speed and duplex with
other devices on the network, or
select 10 HD (half-duplex), 10 FD
(full-duplex), 100 HD, 100 FD, or 1000
FD to lock into a fixed mode.
MAC Address Displays the MAC address of the
interface. It is set at the factory and is
a read-only value.
SNMP Read Only Sets the password to read data from a
device and to display diagnostics
Community String
traps/alarms.
This is used when communicating
with a device within an SNMP
environment.
SNMP Read Write Sets the password to write data to a
Community String device.
This is used when communicating
with a device within an SNMP
environment.
Setup Menu
Parameters
The IP Address/Mask and Gateway
Address should be changed together,
i.e., as a group. The following table
shows the most commonly used
Subnet mask values to enter for a
chosen IP address mask, which will
depend on the size of your network.
Mask Subnet Mask
8 255.0.0.0
16 255.255.0.0
24 255.255.255.0
Auto (default), 1000FD (full duplex),
100HD (half duplex), 10FD, 100FD, or
10HD
N/A
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
Up to 31 alphanumeric characters in
length. This string is case-sensitive.
The default community string is:
public.
89