Cisco D9854 Installation And Configuration Manual page 365

Alarm Message
Type
FPGA status Set
FPGA status Clear
MIP Output Set
Spacing (D9854
with Single
Frequency
Network only)
MIP Output Clear
Spacing (D9854
with Single
Frequency
Network only)
FEC USB Flash Set
(D9854-I only)
Message Cause/Remedy
FPGA ID does not Cause: Hardware
match HW FPGA
issue.
ID
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA loaded –
successfully and
reset
MIP Output Cause: Current
Spacing Erratic - transport rate
exceeds the
Data lost
configured rate for
ASI output.
Remedy: Increase
output rate.
Contact the uplink
to verify the
expected bit rate
settings.
MIP Output –
Spacing Stable
FEC USB Option Cause: FEC USB
connector not
not installed
installed.
Remedy: Ensure
that the FEC USB
connector and
FLASH module
are installed.
Description Severity
FPGA setup Major
failure or the
FPGA binary
identity does
not match the
FPGA registers.
– Major
Severe Minor
differences in
the MIP
packets
detected on the
input versus
the MIP
packets
transmitted to
the ASI output.
– Minor
FEC USB Major
option not
detected.
ID
39000
39000
40500
40500
92300
341