Cisco D9854 Installation And Configuration Manual page 374

Chapter 6 Service and Maintenance
Warning Message
Type
Temperature Set
Warning
Temperature Clear
Warning
FPGA Set
Temperature
Warning
FPGA Clear
Temperature
Warning
VBI Data Set
VBI Data Clear
TDT timeout # Set
350
Message Cause/Remedy
Temperature Cause: Room
over Warning temperature too high, or
threshold air flow is blocked.
Remedy: Check
openings on front and
rear panels for blockage.
Lower the room
temperature or improve
air flow to the device.
Temperature –
normal
Temperature Cause: Room
over Warning temperature is too high,
threshold or air flow is blocked.
Remedy: Check the
openings on front and
rear panels for blockage.
Lower the room
temperature or improve
air flow to the device.
Temperature –
normal
2nd VBI PID Cause: Uplink
attempt to write
configuration issue.
same line
Remedy: Contact uplink
to verify expected VBI
settings.
Line Collision –
Cleared
TDT timed out Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
Description
Temperature is above
normal operating
range.
Temperature is within
the normal operating
range.
FPGA temperature is
above normal
operating range.
FPGA temperature is
within the normal
operating range.
Conflicting VBI data
on second VBI PID.
–
Time Date Table was
never received.
ID
44000
44000
45000
45000
49000
49000
50000