Table of Contents
Advertisement
Menu Item
Description
Select Yes to listen to MPEG over IP streams
isMulticast
sent to a specific multicast IP address (group).
Otherwise, select No to listen to the unicast
MPEG over IP streams sent to the IP addresses
of the Data1 and Data2 ports.
If isMulticast is set to Yes, enter the multicast
IP Address
IP address.
FEC
Type of expected FEC streams for the decoder
to analyze and use.
Src Filter
Select the source (host) filtering mode.
TS UDP
The transport stream UDP port number. For
RTP port, enter an even port number. For UDP
port, you can enter an even or odd port
number.
Note: FEC is only supported for RTP transport
streams.
FEC1 UDP
If FEC is set to 1D or 2D, set the FEC
destination UDP port number of the column
FEC stream.
Setup Menu
Parameters
Yes or No
Valid multicast IP address
None - All FEC streams
are dropped.
1D - Column stream is
expected.
2D - Column and row
streams are expected.
None - All streams sent to
a specific destination IP
address (multicast or
unicast) and destination
TS and FEC UDP ports are
received, without source
restrictions.
White List - The unit will
only receive streams from
the defined list of
hosts/servers (Idx and IP
Address). It will reject the
streams received from the
host/servers that are not
defined on the list.
Black List - The unit will
reject the streams received
from the defined list of
hosts/servers (Idx and IP
Address).
1 to 65534
2 to 65534
83
Advertisement
Table of Contents
