Cisco D9854 Installation And Configuration Manual page 385

Warning Message
Type
SDI VBI (OP47 Clear
SDP)
SDI VBI (OP47 Set
MDP)
SDI VBI (OP47 Clear
MDP)
SDI VBI (OP47 Clear
MDP)
ETH REDN: Set
Link Speed
(D9854-I only)
ETH REDN: Clear
Link Speed
(D9854-I only)
ETH REDN: Clear
Link Speed
(D9854-I only)
ETH REDN: Clear
Link Speed
(D9854-I only)
MPoIP Bitrate Set
Port #<n>
MPoIP Bitrate Clear
Port #<n>
MPoIP Bitrate Clear
Port #<n>
Message Cause/Remedy
Service disabled –
VBI (OP47MDP): Cause: User selection.
configured line
Remedy: Change offset
collides with VII,
for VBI OP47-MDP
service will be
VANC service.
dropped
Line collision –
with VII cleared
Service disabled –
Links speed Cause: Manual
mismatch configuration or auto-
negotiated speed on the
detected
two Data ports is
different.
Remedy: Ensure that the
link speed on paired
ETH ports is identical.
Link speeds are –
identical
Link speed is not –
resolved
Links speed is –
not monitored in
manual modes
Total configured Cause: Aggregated
output is MPoIP bandwidth on
marginal or too
Port <n> is too high.
high
Remedy: Re-configure
the stream's output rate
to be within 90% of the
link speed on ETH port
<n>.
Total configured –
output is normal
Inactive port, –
monitoring
stopped
Description
–
VBI OP47-MDP
VANC service is
configured on the line
overlapping with PAL
or NTSC VII line.
–
–
Link speed is different
for two Data ports.
This condition may
trigger an overflow on
the Data port with a
lower link speed.
–
–
–
The configured MPEG
over IP bandwidth is
close or higher than
ETH port <n> link
speed. This condition
can trigger the actual
MPoIP overflow.
–
–
ID
90050
90060
90060
90060
91000
91000
91000
91000
92000
92100
92000
92100
92000
92100
361