Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
12 Click Apply.
13 Click Copy to ASI to copy all the DPM data from the MPEG over IP output to
the ASI output.
Viewing the MPEG Output Transport Status
From the user interface of the D9854/D9854-I, choose Transport Stream > Output
Transport Status under MPEG over IP Output. The PID Output Status page is
displayed.
The Program Entry - Referenced PIDs table displays the specified PE ES PIDs
information on the output.
The Output Channel and PID Conflicts table displays a list of conflicts when the
DPM alarm is active.
Typical set up for Digital Program Mapping (DPM)
1
Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop, or map.
2
From the user interface of the D9854/D9854-I, choose Transport Stream > ASI
Output or MPEG over IP Output.
3
From the Output Mode drop-down list, choose Full DPM Control.
258
Advertisement
Table of Contents
