Table of Contents
Advertisement
Setting up IP Unicast Routing Information
1
From the user interface of the D9854/D9854-I, choose System Settings > IP
Settings > IP Routing. The IP Routing page is displayed.
2
From the RIP drop-down list, choose Enable to enable the Routing Information
Protocol (RIP). Otherwise, choose Disable. This is a standard protocol for
automatic unicast route discovery. If enabled, the routing information is
displayed in the Installed Unicast Routes table.
3
Click Apply.
4
In the Static Unicast Routing table, you can set the static unicast routing
information used to by MPEGoIP and MPE outputs to send data packets. It can
also be used to find hosts behind a router (for example, an FTP server, a syslog
server, or an NTP server).
Configuring System Settings
269
Advertisement
Table of Contents
