Table of Contents
Advertisement
Chapter 4 Front Panel Operation
Menu Item
Reset Credentials
Password
Complexity
SNTP Server
SNTP Enable
Passw ord Complex ity
Password Complexity
No Checking
90
Description
If for some reason, you cannot access
the decoder (due to a forgotten
password, corrupted data, and so on),
the recovery procedure for the
decoder is as follows:
Using the keypad, choose this field on
the front panel menu. A default login
username and randomly generated
password will be displayed on the
front panel display for approximately
30 seconds. The new account will
have Admin privileges. We
recommend that this account be
replaced by a login
username/password chosen by the
administrator. To change the
username and password, you must be
an Admin user. Refer to Setting
Admin User Privileges via a
Telnet/SSH Connection (on page 38).
Note: After this recovery procedure,
all existing user accounts will be lost.
Sets the password complexity for all
users. The complexity level changes
will only affect the new user accounts
and password changes. It will not
affect existing accounts.
Sets the NTP server address. If the
NTP server address is not set (0.0.0.0),
the IRD will not attempt to connect to
the server.
Periodically request NTP timestamps
from the NTP server and to
synchronize its system (i.e., non-DVB
related) time with the NTP server.
Description
There are no restrictions on passwords.
Parameters
–
No Checking, Minimal Checking, or
Full Complexity Checking
For more information, see the
Password Complexity table below.
12 digits in length (###.###.###.###)
Yes or No
Advertisement
Table of Contents
