Cisco D9854 Installation And Configuration Manual page 367

Alarm Message
Type
FEC FPGA Set
Status
(D9854-I only)
FEC FPGA Set
Status
(D9854-I only)
FEC FPGA Set
Status
(D9854-I only)
FEC FPGA Clear
Status
(D9854-I only)
Message Cause/Remedy
FEC FPGA failed Cause: Hardware
to start issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA access Cause: Hardware
failed issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA Cause: Hardware
initialization failed issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is –
running OK
Description Severity
FEC FPGA is Major
loaded, but
failed to start
(not ready).
FEC FPGA is Major
loaded and
started,but
attempt to read
configuration
registers failed.
FEC FPGA is Major
loaded and
started, but
initial
parameter
setup failed.
FEC FPGA is Major
loaded, started,
initialized, and
is fully
operational.
ID
92400
92400
92400
92400
343