Setting Up The Moip Outputs - Cisco D9854 Installation And Configuration Manual

Chapter 2 Quick Setup - Read Me First!

Setting up the MOIP Outputs

The following displays the rear panel of the D9854 Base Model:
1 Press MENU to move to the Main Menu.
2 Press
3 Press
4 Press
5 Press
Rate Control. Use
device setting the output rate to be the same as the input rate. Press SELECT.
Note: You can set the User Rate in Step 9.
6 Press
output mode for your application. Press SELECT.
7 Press
the scrambling mode. Press SELECT.
8 Press . Press
the selection to No. Press SELECT.
9 Press
10 Move
desired bit rate. Press SELECT to save changes.
11 Press
Press SELECT.
12 Press . Press SELECT. Enter the Destination Address using the keypad. Press
SELECT. Press
using the keypad. Press SELECT to save the change. Press
Press SELECT and enter the port number using the keypad. Press SELECT to
save the change. The default is zero, which allows the system to assign a port.
13 Press
SELECT. Press
14 Press MENU to exit the menu level and save the changes.
22
to move to the Setup menu. Press SELECT.
to move to the Outputs menu. Press SELECT.
to move to the TS Out menu. Press SELECT.
to move to the MOIP menu. Press SELECT. Press . Press SELECT for
to select User. Selecting Auto for Rate Control results in the
to move to the Output Mode. Press SELECT. Use
to move to Descrambling Mode menu. Press SELECT. Use
to move to Insert Null Packet. Press SELECT. Use
to move to the MOIP Streams menu and press SELECT.
to the User Rate menu. Press SELECT and use the keypad to enter the
two times. Press SELECT. Use
to move to UDPPort. Press SELECT and enter the port number
two times. Press two times to move to PCR@IP Start menu. Press
to set value to No. Press SELECT to save the value.
to choose the
to change the selection to UDP or RTP.
to move to SrcPort.
to select
to change