Table of Contents
Advertisement
Menu Item
TTL (Time To Live)
DestAddr
UDPPort
SrcPort
Send SAP
SAP Multicast
Address
SAP Port
SAP ID
SAP User Str
FEC
Description
This sets the hop limit of the
packet's lifespan.
Enter the unicast (valid host IP
only) or multicast destination
IP address.
This selects the destination port
number.
This selects the source UDP
port number.
This selects whether to send
Session Announcement
Protocol messages.
This is the IP address where the
SAP announcements are sent, if
required.
This is the UDP port where the
SAP announcements are sent, if
required.
Describes the SAP output
stream name source.
Provides the SAP user string.
Select the error protection
profile.
For more information, see
Configuring Forward Error
Correction Settings (on page
248).
Parameters
0 to 255
Unicast: valid host IP
Multicast: IP in range of 224.0.0.0 to
239.0.0.0
Note: We do not recommend that you
use multicast IP addresses reserved
by the Internet Assigned Numbers
Authority (IANA).
1 to 65534
Note: If you selected RTP for MOIP,
you must select an even destination
port number.
Note: We do not recommend that you
use destination UDP ports reserved
by the IANA.
0 to 65535
Note: Set the SrcPort to 0 to use the
default source UDP port (49162).
None or RFC2327
We do not recommend that you
change the default IP address
(224.2.127.254).
1 to 65534
Note: We do not recommend that you
change the default SAP port 9875.
User String or SDT Channel
Up to 31 characters
1D - Requires generation of one FEC
protecting stream: columns.
2D - Requires generation of two FEC
protecting streams: columns and
rows.
None - Disables the error protection.
Note: For more information, see
SMPTE 2022-1-2007.
Setup Menu
123
Advertisement
Table of Contents
