Table of Contents
Advertisement
Chapter 4 Front Panel Operation
Menu Item
FEC2 UDP
Source IP Select
DATA1/DATA2
Algorithm
Latency (ms)
Redundancy Mode
Type
Direct Delay
84
Description
If FEC is set to 2D, in addition to entering the
port number of the column FEC stream, enter
the FEC destination UDP port number of the
row FEC stream.
Displays the detected host.
Displays whether the detected host (Source IP
Select) is available on DATA1 and/or DATA2
ports.
The de-jitter algorithm.
Buffer latency (delay), in milliseconds.
Select the type of redundancy for the MOIP
input data.
If Backup: Primary Data1/Data2 is set as the
Redundancy mode, select the redundancy
direction.
Time to wait before switching from the
primary data port to the backup data port after
the system detects a failure on the primary
port.
Parameters
2 to 65534
Valid host IP address or
0.0.0.0 if none is found.
Yes or No
VBR, CBR
110 to 150 if VBR is
selected as the Algorithm.
40 to 150 if CBR is selected
as the Algorithm.
Manual Data1/Data2 -
Only use Data1 (port 1) or
Data2 (port 2) for input
data. The remaining
redundancy controls
below are not applicable.
Backup: Primary
Data1/Data2 - Use port 1
or port 2 as the primary
data port. If an issue
occurs, it will failover to
port 2 or port 1 (the
backup port).
Revertive - Attempt to
revert back to the primary
port when using the
backup port and the
primary port is active
again.
Non-revertive - Use the
backup port (if active)
when the primary port
fails, without reverting
back to the primary port,
under any condition.
0 to 1000 milliseconds
Advertisement
Table of Contents
