Ricoh S-P2 Service Manual page 99

5801 011 NCS
5801 014 DCS Setting
5801 015 Clr UCS Setting
5801 016 MIRS Setting
5801 017 CCS
5801 018 SRM
5801 019 LCS Setting
Free Run
The machine performs a free run.
5802
Press [#Enter] to start.
Press [#Enter] to stop.
Please note that the machine will not stop immediately after the [#Enter] key is pressed.
Input check
5803
Displays signals received from sensors and switches.
SP Modes other than those listed in this table, are not used in the machine.
Operation Panel
5803 001 Cover Info
5803 002 Main Moter CLK
5803 003 PollyMoter CLK
5803 004 Fan High
5803 005 Fan Lock
5803 006 PSU Fan Lock
Initializes the system defaults and interface settings (IP
addresses also), the SmartNetMonitor for Admin settings,
WebStatusMonitor settings, and the TELNET settings.
(NCS: Network Control Service)
Initializes the DCS (Delivery Control Service) settings.
Initializes the UCS (User Information Control Service) settings.
Initializes the MIRS (Machine Information Report Service)
settings.
Initializes the CCS (Certification and Charge-control Service)
settings.
Initializes information in non-volatile RAM.
Initializes information in non-volatile RAM.
Component Name
Cover sensors
Main Motor Lock
Polygon Motor Lock
Exhaust fan
Exhaust fan
PSU fan
Printer Engine Service Mode
5
97