Ricoh S-P2 Service Manual page 111

Downloads the content of a flash memory card to the NVRAM on the control board.
Network
This machine supports both Internet Protocols IPv4 and IPv6. IPv6 is the next generation
5828
protocol designed by the IETF to replace IPV4. IPv6 adds many improvements such as
routing and network auto-configuration.
5828 022 ActIPv4 SbNet
5828 023 ActIPv4Gatew
5828 045 Bi Direct Centro
5828 050 1284 Compatible
5828 052 ECP
5828 065 Job Spool
5828 066 HD job Clear
This SP allows you to confirm the IPv4 subnet mask setting that
was used when the machine started up with DHCP. For example,
if the setting for the IPv4 subnet mask is "FFFFFF00H" this is
displayed as "255.255.255.000"
This SP allows you to confirm the IPv4 default gateway setting
that was used when the machine started up with DHCP. For
example, if the setting for the IPv4 gateway is "0C0A80001h"
this is displayed as "192.168.000.001".
Enables and disables the Centro communication.
[0to1/1]
0:Off, 1: On
Enables and disables bi-directional communication on the
parallel connection between the machine and a computer.
[0to1/1]
0:Off, 1: On
Disables and enables the ECP feature (1284 Mode) for data
transfer.
[0to1/1]
0: Disabled
1: Enabled
Switches job spooling spooling on and off.
0: No spooling, 1: Spooling enabled
This SP determines whether the job interrupted at power off is
resumed at the next power on. This SP operates only when
SP5828 065 is set to 1.
1: OFF (Resumes printing spooled jog.)
0: ON (Clears spooled job.)
Printer Engine Service Mode
5
109