Ricoh S-P2 Service Manual page 103

0: OFF (Remote service off)
2: Network (@Remote remote service on)
CE Call
Performs the CE Call at the start or end of the service.
[0 or 1 / 0 / 1 /step]
5816 002
0: Start of the service
1: End of the service
NOTE: This SP is activated only when SP 5816-001 is set to "2".
Function Flag
Enables or disables the remote service function.
5816 003
[0 to 1 / 0 / 1 /step]
0: Disabled
1: Enabled
SSL Disable
Uses or does not use the RCG certification by SSL when calling the RCG.
5816 007
[0 to 1 / 0 / 1 /step]
0: Uses the RCG certification
1: Does no use the RCG certification
RCG Connect Timeout
5816 008
Specifies the connect timeout interval when calling the RCG.
[1 to 90 / 10 / 1 second /step]
RCG Write Timeout
5816 009
Specifies the write timeout interval when calling the RCG.
[1 to 100 / 60 / 1 second /step]
RCG Read Timeout
5816 010
Specifies the read timeout interval when calling the RCG.
[1 to 100 / 60 / 1 second /step]
Port 80 Enable
5816 011
Enables/disables access via port 80 to the SOAP method.
-
Printer Engine Service Mode
5
101