Ricoh S-P2 Service Manual page 93

Thermistor Adj DFU
If this is "Yes", the machine automatically adjusts the charge roller voltage and transfer
2910
current in response to the temperature in the machine.
[Yes/ No]
Waste Toner Cnt
2980
Displays the waste toner count.
SP3-xxx: Process
Cartridge Stop
Determines whether the machine stops printing after the cartridge counter reaches a set
number of main motor rotations.
3923
[0 or 1 / 1 /-]
0: No: Does not stop after the number of rotations is exceeded.
1: Yes: Stops after the number of rotations is exceeded.
3924 Toner End Sensor
3924 001 Toner Near-end
3924 002 Toner End
Prevention of fi
No, Yes
If set to "Yes": This is done every 50 prints, for 0.2 s, to lubricate the cleaning blade. The
charge roller voltage is cut, and toner is transferred to the cleaning blade. If the 50-print
interval is reached during a job, printing stops and this process is done.
3926
Set this to yes to prevent the following:
• Grey banding parallel to the paper feed direction
• Cleaning blade flipping due to friction between blade and drum
• Noise due to friction between blade and drum
Thermistor Adjustment
Used Toner Count
Threshold adjustment for toner near-end detection.
[100 to 1000/200/100 ms step]
Threshold adjustment for toner end detection.
[100 to 1000/550/100 ms step]
Prevention of Filming
Printer Engine Service Mode
5
91