Ricoh S-P2 Service Manual page 75

1st/2nd Message
Remove Misfeed Paper Tray/ Pull out
Tray
Remove Paper Standard Tray
Replace Maintenance Kit
Replace Print Cartridge
Replace Print Cartridge
Replace Print Cartridge
Replace Print Cartridge soon
Reset Fusing Unit correctly
Reset Print Cartridge
Reset Tray # or Form Feed
Reset the Job or Form Feed/ Paper
Size:, Paper Type:
Problem/Solution
Paper is jammed in the specified input paper tray.
• Remove paper from the input paper tray.
• Reload paper.
• Open and close front cover to extinguish message.
The standard output tray is full.
• Remove paper from output tray.
It is time to replace: feed roller, transfer unit, fusing unit,
development unit.
Print cartridge requires replacement.
Print cartridge requires replacement (out of toner).
Print cartridge requires replacement (used toner tank full).
The print cartridge is out of toner or has reached the end of its
service life. Print cartridge requires replacement.
Fusing unit not set correctly, or incorrect type installed.
• Check the type of fusing unit installed.
• Confirm that unit is installed correctly.
AIO unit not installed or is not installed correctly.
• Insert AIO.
• Check that it is inserted properly.
Specified paper input tray is not set correctly. (Current resident
printer languages only).
• Set input tray correctly.
Actual paper type and size do not match the paper tray size
and type setting.
• Load the indicated tray with the correct paper.
• Or, change the paper size using tray dial or operation
panel.
• Or, push [Form Feed] to print on current paper.
• Or, cancel job.
Error Messages
4
73