Ricoh S-P2 Service Manual page 164

5. Service Tables
2. Insert the SD card into the service slot (lower) of the controller board. Then turn the power ON.
• To determine which slot is the service slot, please see the service manual.
3. Enter SP mode.
4. Select "Service" and press "#Enter" button twice.
5. Select "Bit Switch 1"and press "#Enter" button.
6. Use the arrow key to turn "Bit Switch 4" and press "Enter" and use the arrow key to turn bit 4 ON.
The result should look like: 00010000. By doing this Card Save option will appear in "List/Test Print".
5
7. Press the "Escape" button several times, and use arrow key to select "3 End" to exit SP Mode.
8. Press the "Menu" button.
9. Use the arrow key and select "List/Test Print".
10. Use the arrow key and select "Cardsave (ADD) or Cardsave (New).
11. To enable the newly configured settings, select "#" button and then press the "Escape" button to exit
the "List/Test Print" menu.
12. Send a job to the printer.
13. As soon as the printer receives the data, it will be stored on the SD card automatically with no print
output. Nothing is displayed on the screen indicating that a Card Save operation was successful.
14. Press the "Suspend/Resume" button and then the "Escape" button to exit Card Save mode.
162