Ricoh S-P2 Service Manual page 112

5. Service Tables
5828 069 JobSpool Protocl
This SP determines whether job spooling is enabled or disabled for each protocol. This is
a 8-bit setting.
0: LPR/ 1: FTP (Not Used)/ 2: IPP/ 3: SMB/ 4: BMLinks (Japan Only)/
5: DIPRINT/ 6: Reserved (Not Used)/ 7: Reserved (Not Used)
5828 090 TELNET
5
5828 091 Web
5828 145 ActIPv6LinkLocal
5828 147 ActIPv6Sttles1
5828 149 ActIPv6Sttles2
5828 151 ActIPv6Sttles3
5828 153 ActIPv6Sttles4
5828 155 ActIPv6Sttles5
5828 156 IPv6Manual Address
110
Disables or enables Telnet operation. If this SP is disabled, the
Telnet port is closed.
[0to1/1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0to1/1]
0: Disable
1: Enable
This is the IPv6 local address referenced on the Ethernet or
wireless LAN (802.11b) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated. See
"Note: IPV6 Addresses " below this table.
These SPs are the IPv6 stateless addresses (1 to 5) referenced
on the Ethernet or wireless LAN (802.11b) in the format:
"Stateless Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each.
This SP is the IPv6 manually set address referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Manual Set Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8
blocks of 16 bits each. These notations can be abbreviated. See
"Note: IPV6 Addresses" below this table.