Ricoh S-P2 Service Manual page 149

• The first selection "Engine" will appear about 1 min. after switching the power on.
6. Scroll to the program to upgrade, then press [#Enter].
7. Press the [Online] to start the upgrade. You will see a series of messages. If you selected "Engine",
for example", you would see:
ROM Update
*****************
Updating
*****************
Updated
Power Off On
The "Power Off On" message appears after about 90 sec.
8. Turn off the power, remove the SD card from Slot 2, and turn on the power.
-or-
If you intend to update another program, leave the SD card in Slot 2 and turn on the power.
• The firmware has not updated successfully if the "Power Off On" message does not appear. If
this occurs, turn the machine power off/on and repeat the procedure.
Error Messages
RTB 20
Firmware Update
5
147